|
Contains
Glutaraldehyde, Fluoride and Water
Pulpdent
Dentin Desensitizer
contains 5% glutaraldehyde in water. It can be applied
to all dentin surfaces, including cavity, crown and
inlay preparations and cervical areas, as a desensitizing
agent.
Pulpdent
Dentin Desensitizer
is not a dentin primer; however, it can be used in conjunction
with adhesives and composites, as well as with provisional
and permanent traditional dental cements. It does not
interfere with bonding techniques and does not affect
bond strengths of adhesives, composites and resin cements.
Fluoride
is added to the Desensitizer to enhance the stability
of the solution. Pulpdent makes no claim as to the therapeutic
benefits of the fluoride or the antimicrobial effect
of glutaraldehyde.
|
| Directions
for Use
For
Bonded Restorations
- Prepare
tooth to receive a restoration.
- Etch
and rinse well.
- Remove
excess water, but do not dry dentin.
- Shake
bottle well, and dispense a small amount into a mixing
well.
- Using
a cotton pellet, apply Desensitizer to dentin for
20-30 seconds.
- Blot
or apply short blast of air to remove excess, but
do not dry.
- Apply
adhesive primer and proceed with bonding technique
using your preferred materials..
Traditional
Restorations
- Prepare
tooth to receive a restoration.
- Do
not etch dentin.
- Shake
bottle well and dispense a small amount into a mixing
well.
- Using
a cotton pellet, apply 2 coats of Desensitizer to
dentin, drying surface after each coat.
- Proceed
with restoration.
Cervical
Sensitivity
- Clean
area with a slurry of pumice, if necessary.
- Gently
blot the sensitive area with a cotton pellet to remove
excess water
- Protect
gingiva with suitable gingival protection material
- Shake
bottle well and dispense a small amount into a mixing
well.
- Using
a cotton pellet, carefully apply Desensitizer to the
cervical area of the tooth, rubbing it for 20-30 seconds,
and gently air dry. Repeat this step 2 or 3 more times.
- The
effect of Pulpdent Dentin
Desensitizer can be tested any time during this
procedure by applying a short blast of air to the
treated area.
Note:
It is not necessary to etch the cervical area unless.a
bonded restoration will be placed, in which case the last
coat should not be dried.
Vital
Bleaching
When sensitive teeth compromise the patient’s desire
to wear a bleaching tray, apply 3-4 coats of Pulpdent
Dentin Desensitizer
to the cervical area. Take care to protect the gingiva
with a suitable gingival protection material prior to
application of the Desensitizer.
Storage
Store tightly closed in original container. Keep product
refrigerated. Do not freeze. Return to room temperature
before use. Shake for 10 seconds before use.
|
|
|
|
