Directions:
- Prepare
cavity, rinse and dry.
- Place
a pink 20 gauge dispenser tip securely onto Lime-Lite
syringe.
- Apply
Lime-Lite to the dentin in
increments. Pull back on syringe plunger to stop flow
of material . The first layer should be not more than
1/2mm thick. Remove Lime-Lite from enamel margins
and light cure for 20-30 seconds, depending on the
light you are using.
- Apply
additional layers, if indicated, in increments of
1.5mm-2mm. Remove Lime-Lite
from enamel margins and light cure each layer for
30 seconds.
- Proceed
with restoration.
Note:
Lime-Lite
has a urethane dimethacrylate base and is similar in
chemistry to dental composites. It chemically bonds
to composites and adhesive primers.
When increased bond strength to dentin is desirable,
apply DenTASTIC
or your preferred dental adhesive to the dentin in accordance
with the instructions for use for the adhesive primer.
then apply Lime-Lite over the
adhesive primer following instructions #2-5 above.
For direct pulp capping, we recommend placing Pulpdent
Paste or Multi-Cal
on the exposed pulp. Lime-Lite
can be applied over the pulpal dressing and light cured.
If using Lime-Lite under water
based cements, such as zinc phosphate, polyacrylic or
glass ionomer cement, remove any uncured resin from
the Lime-Lite surface (oxygen inhibited layer) by wiping
it with a pledget of cotton miostened with alcohol.
|
