|
Directions
for Cavity Lining and Indirect Pulp Capping:
- Apply
a very thin film to the dentin.
- Dry
with a slow flow of air until material appears chalky
white (30 seconds)
- Remove
from the enamel margins.
- When
using glass ionomer and dentin bonding materials,
place Multi-Cal in the deepest
part of the cavity, leaving the facing walls available
for dentin bonding.
Directions
for Direct Pulp Capping:
- Apply
a very thin film of Multi-Cal
on all exposed dentin and dry with a slow flow of
air.
- Place
a bead of Multi-Cal 3mm thick directly over the exposed
pulp and dry with a slow flow of air until a crust
appears. Multi-Cal does not set hard.
- Gently
tamp the paste with a pellet of cotton to make sure
it is in contact with the pulp.
- Place
a thin mix of hard setting cement over Multi-Cal.
- After
cement hardens, place final restoration.
Note:
For pulpotomy and pulpal curettage procedures, pack
pulp gently with sterile cotton until blood clots, then
proceed as above. A local anesthetic may be used.
Note:
To extend shelf life, place a few drops of water
in the cap and recap the syringe immediately after use.
If using disposable applicator tips to dispense Multi-Cal,
use a new tip for each patient.
Directions
for Root Canal Therapy:
- Prepare
and cleanse canal in conventional manner.
- Fill
canal with Multi-Cal.
- Seal
access opening with your preferred cement.
- Multi-Cal
is easily removed with file and irrigation.
- In
cases requiring extended root canal therapy, change
dressing every month.
|
