Mixing
Information:
- Mixing
Ratio: 2.5-2.63g powder : 1 g liquid at 22 degrees
C, or 1 scoop powder : 1 drop liquid
- Minimum
Ratio: 2 scoops powder : 2 scoops liquid (or multiples
thereof)
- Mixing
Time: 30 seconds
- Working
Time: 2 minutes
- Initial
Setting Time: 4 1/2 minutes
- Ready
to Polish: 7 minutes from beginning of mix.
Please
Note:
The
above times are based on normal room temperature (72oF,
22oC). Warmer or cooler conditions may alter
these times. If possible, use product at normal room temperature.
Mixing
Instructions:
- Prior
to measuring powder, gently shake or invert powder
bottle several times to fluff powder.
- Place
two or more level scoops of powder into three equal
piles.
- Dispense
two or more drops of liquid on the mixing pad by holding
bottle vertically and gently squeezing. Release pressure
after each drop and gently squeeze again to dispense
next drop. Wipe tip clean and replace cap. Drops of
liquid must equal scoops of powder.
- Use
plastic spatula and incorporate one-third of the GlassFill
powder at a time into the liquid. Mix for 30 seconds
with a flattening action to a homogenous, composite-like
consistency.
Instructions
for Use:
- Prepare
cavity in usual manner. Prepare and clean stained
enamel with pumice or oil-free paste. Dovetail preparation
for mechanical retention.
- Use
rubber dam to isolate treatment area from moisture
or saliva contamination.
- Place
Pulpdent Cavity Liner or other calcium hydroxide liner
in deep areas only.
- Apply
Pulpdent Bond Conditioner with a cotton or sponge
pledget onto all exposed dentin surfaces for 10 seconds
or etch dentin and enamel with Etch-Rite
(38% phosphoric acid gel) in accordance with instructions
for use. Wash and dry.
- Mix
GlassFill according
to mixing instructions above.
- Place
GlassFill on prepared tooth and contour. This procedure
is similar to that used for restorative composites
and silicates. When using stainless steel matrix bands,
first coat them lightly with Vaseline. Plastic matrix
can also be used. Initial setting time is 7 minutes
after mix.
- Wait
10 minutes after placing GlassFill
before finishing and polishing with a fine diamond
or other rotary instrument.
- Cover
GlassFill with
glass ionomer varnish.
Instructions
for Fissure Filling:
Open fissures to a depth of 2mm. Remove all caries.
Wash and dry treatment site. Fill fissures following
instructions above.
Precautions:
GlassFill liquid contains polyacrylic acid. Avoid contact
with eyes. If eye contact is made, wash eyes with copious
amounts of water. See your physician immediately if required.
Wash
and clean GlassFill
from instruments immediately after use. Wipe dry with
clean towel.
Keep
powder and liquid bottles tightly covered when not in
use. Store in cool dry area.
|
