Mixing
Information:
- Mixing
Ratio: 0.186 g powder : 0.133 g liquid, or 2 scoops
powder : 3 drops liquid
- Minimum
Ratio: 2 scoops powder : 3 drops liquid (or multiples
thereof)
- Dispense
3 drops of GlassLute liquid onto mixing pad for each
2 scoops of GlassLute powder.
- Using
a suitable spatula, incorporate GlassLute powder into
the liquid and thoroughly mix with a flattening action
for 20 seconds.
- Glasslute
has a working time of 3 minutes.
Please
Note:
The above times are based on normal room temperature
(72oF, 22oC). Warmer or cooler
conditions may alter these times. If possible, allow
product to reach room temperature before using.
Mixing Instructions:
- Prior
to measuring, gently shake or invert
GlassLute powder bottle several times to fluff
powder.
- Dispense
2 level scoops of GlassLute powder, or multiples thereof,
onto mixing pad.
- Dispense
3 drops of liquid onto mixing pad for each 2 scoops
of GlassLute powder.
- Using
a suitable spatula, incorporate GlassLute powder into
the liquid and thoroughly mix with a flattening action
for 20 seconds.
- GlassLute
has a working time of 3 minutes
Instructions for Use:
- Prepare
tooth in usual manner.
- Use
routine procedure to avoid contamination by crevicular
fluids.
- In
deep seated areas, it is recommended to apply a thin
film of Pulpdent Cavity
Liner (calcium hydroxide liner) on the pulpal
floor to insure against desiccation of the dentin
tubules and pulpal sensitivity.
- Mix
GlassLute following the above prescribed mixing instructions.
- Place
GlassLute into crown or other retainer or onto appliance.
GlassLute has
a working time of 3 minutes after mixing.
- Seat
crown or other appliance in usual manner and allow
to initially set. Initial setting time is 6 minutes
after mixing.
- Trim
away excess GlassLute at the margins and other areas
with a sharp instrument.
- Immediately
cover margins and exposed Glasslute
with Pulpdent Glass Ionomer Varnish, copal varnish
or a light cure dentin/enamel bonding resin. This
will prevent seepage of oral or crevicular fluids
through the margin during initial set. Final set occurs
after 24 hours.
Precautions:
Glasslute liquid
contains polyacrylic acid. Avoid contact with eyes. If
eye contact is made, wash eyes with copious amounts of
water. See your physician immediately if required.
Wash
and clean GlassLute from instruments immediately after
use. Wipe dry with clean towel.
Keep
powder and liquid bottles tightly covered when not in
use. Store in cool dry area.
|
