INSTRUCTIONS FOR USE
Slightly moist tooth surfaces exhibit neither dryness nor pooling of water. Lightly dry and remove excess water with compressed air or a cotton pellet. Tooth surfaces should be shiny or glossy. Overly wet surfaces will result in decreased bond strength.

1. Create retention form and prepare tooth for a Class V restoration.
2. Isolate treatment area and dry lightly with oil-free compressed air.
3. Etch enamel and cementum for 15 seconds with Etch-Rite 38% phosphoric acid etch gel, or microabrade enamel and cementum. Rinse well. Do not disturb this surface.
   NOTE: Etching dentin and the use of bonding agents may not be required; however, they are not contraindicated, and they can be used, if desired. When bonding agents are used, they are recommended on the floor of the restoration only.
4. Lightly dry and remove excess water with a cotton pellet or clean compressed air. LEAVE TOOTH SURFACES SLIGHTLY MOIST. Slightly moist tooth surfaces should appear shiny or glossy. Overly wet surfaces will result in decreased bond strength. Embrace WetBond Class V bonds to tooth surfaces that are slightly moist from saliva; however, it is best to avoid bacterial contamination.
5. Apply Embrace Class V to the prepared tooth surface.
6. Light cure. Class V cures with all lights. Curing time for a halogen light with a minimum of 300 mW/cm2 is 20 seconds. More powerful lights will cure faster.
7. The application of Seal-n-Shine will provide durability, exceptional marginal integrity and esthetic results. Seal the restoration and margins with Seal-n-Shine by following the Seal-n-Shine instructions