1. Clean, isolate and etch tooth for 15 seconds. Rinse well.
   LEAVE TOOTH SURFACE SLIGHTLY MOIST.
2. Apply Embrace sealant on slightly moist occlusal surface.
3. Light cure

INSTRUCTIONS FOR USE
Slightly moist surfaces exhibit neither dryness nor pooling of water. Remove excess water with compressed air or a cotton pellet. Surfaces should be shiny or glossy. Overly wet surfaces will result in decreased bond strength.

1. Thoroughly clean enamel surfaces with oil-free cleaning paste.
2. Rinse well, removing all residual paste from pits and fissures.
3. Prepare questionable enamel and small lesions in the usual manner.
4. Isolate treatment area and dry lightly with oil-free compressed air.
5. Apply Etch-Rite 38% phosphoric acid etching gel to the clean tooth surface for 15 seconds. Rinse well. Do not disturb this surface.
6. Remove excess water with a cotton pellet or clean compressed air. LEAVE TOOTH SURFACES SLIGHTLY MOIST. Moist surfaces should appear shiny or glossy. Overly wet surfaces will result in reduced bond strength.
7. Embrace bonds to surfaces slightly moist from saliva; however, it is best to avoid bacterial contamination.
8. Place applicator tip securely on Embrace syringe and carefully start flow of sealant. Use a new applicator tip for each patient.
9. Apply Embrace to the prepared tooth surface. For pit and fissure sealing, flow the material from cusp to cusp, but do not cover the marginal ridges.
10. Light cure. Curing time for a halogen light with a minimum of 300 mW/cm2 is 20 seconds.
11. Check and adjust occlusion, if necessary.