INSTRUCTIONS FOR USE
Dry ceramic, metal and cured resin surfaces. Leave prepared tooth surface slightly moist. Slightly moist tooth surfaces exhibit neither dryness nor pooling of water. Lightly dry and remove excess water with compressed air or a cotton pellet. Tooth surfaces should be shiny or glossy. Overly wet surfaces will result in decreased bond strength.

1. For enamel and composite, etch or microabrade for 10 seconds. For ceramic surfaces, place rubber dam and etch with Pulpdent Porcelain Etch Gel for 2 minutes. Pulpdent Kool-Dam should be used to protect soft tissue, teeth or porcelain surfaces, as required.
2. Rinse well. Dry ceramic, metal and cured resin surfaces. Lightly dry enamel and leave prepared tooth surface slightly moist.
3. When necessary, place dental floss through the contacts and leave it in the embrasures. Use later to clear contacts and prevent bonding to adjacent tooth surfaces. The teeth can be wedged and a mylar strip can be placed, if desired.
4. Apply a thin coat of Seal-n-Shine to the etched tooth and restorative surfaces with a flocked dispenser tip or a clean brush.
5. Remove the dental floss by lifting interproximally through the contacts. It is important for the contacts to be open.
6. Light cure. Seal-n-Shine cures with all lights. Curing time for a halogen light with a minimum of 300 mW/cm2 is 20 seconds. More powerful lights will cure faster.